Page 2-10
200 SPECIFICATIONS
Torque Specifications for Hose Clamps
V-MAC components (cont.)
Lower support bracket-to-cylinder block capscrews 40 54
Upper support bracket-to-injection pump capscrews 15 20
Timing event marker (TEM) 22 30
V-MAC 7-pin pump connector 15 20
Bracket-to-block capscrews 40 54
Hose clamp screw 15 20
RPM/TDC (engine position) sensor (jam nut) 15 20
MPH (road speed) sensor (jam nut) 15 20
Engine oil pressure sensor 6 8
Intake manifold temperature sensor 23 31
Coolant temperature sensor 23 31
Coolant level sensor 23 31
Bulkhead connector (jackscrew) 5 7
V-MAC module connector (jackscrew) 2 3
V-MAC ELAB valve terminal nut 3 4
Fuel injection pump actuator connector 15 20
Electrical equipment panel mounting leg hardware 6 8
Electrical equipment panel accessory studs 2 3
Timing solenoid to Econovance (four bolts) 15 20
Water manifold screw 25 34
Water pump cover-to-water pump housing screw 15 20
Water pump shaft locknut 90 122
Water pump-to-cylinder block screw 60 81
Torque Specifications for Critical Fasteners (Cont.)
Description
Torque
Lb-Ft N•m
a
English threads.
b
V-MAC applications.
Hose Clamps
Torque
Lb-In N•m
SAE J536 Type F
Air inlet systems 38 4
Water or coolant systems 28 3
Oil drain systems 28 3
Hi-torque heavy-duty worm clamp 80 9
T-bolt type hose clamp 50 6
NOTE: The band of any hose clamp in all installations should be a minimum of 0.090 inch (2.290 mm) from the end of the hose
and must be clear of tube bead.
5-101.bk Page 10 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
