200 ENGINE ASSEMBLY
Page 6-65
[261 CK] AIR COMPRESSOR
Installation
Refer to Figure 6-75.
1. Install a new gasket on the air compressor
mounting flange.
2. Check to ensure that the lubrication oil
supply tube (2) is in place and position the
air compressor (1) on the mounting flange.
If the oil supply tube is lost, the air compressor
will fail from lack of oil.
3. Install the three mounting capscrews (5) and
torque to 70 lb-ft (95 N폷m) using torque
wrench J 24407 or equivalent.
4. Reconnect the coolant lines to the air
compressor cylinder head.
Figure 6-75 — Air Compressor Installation
200360a
1
2
3
4
5
1. Air compressor
2. Oil supply
3. Auxiliary driveshaft
4. Oil drain openings
5. Capscrew
5-101.bk Page 65 Friday, March 17, 2006 11:05 AM
To Next Page
Loading...
