22
Listen to other devices
You can connect an external audio/video device to be unit.
1. Connect the car audio to the device with the supplied AV cable.
2. Touch the upper left corner to display the main menu.
3. Touch [AV-IN1] / [AV-IN2].
4. Operated the connected the device(see the instructions manual of the device).
Tip
If you connected the system to other audio device through the REAR OUT L/R connectot(see
“Connect wires” section), touch [AV-IN] to listen to that device.
Reset
When the unit hangs up, you can reset it.
Press RESET with a ball-point pen or similar tool.
Tip
When the unit is reset,all the settings remain unchanged.
Remove the unit
To repair ,replace fuse ,or replace the unit with another car audio,remove it from
the dashboard.
1. Take off the trim plate.
2. Screw off the four screws on the left/right side of the unit.
3. Pull the unit out from the dashboard.
Replace fuse
If there is no power,the fuse may be damaged and need to be replaced.
1. Take out the unit from dashbpard.
2. Check the electric connection.
3. Buy a fuse that matches the voltage of the damaged fuse.
4. Replace the fuse.
GPS
1. Touch the upper left corner to display home menu.
2. Touch [Navigation], the navigation menu is display in a few seconds.
3. Refer to the map manual to operate the navigation tool.
Tip:
You can press [NAV] button of the panel to enter/exit the navigation system.
Other modes
To Next Page
Loading...
Need help?
General
