HANDLING
STARTING CHECK
Operating Manual MT 25 / 30 YT 93
Daily checks after starting the motor
oil level transmission
CAUTION!
Transmission damage!
If the oil level is too high or too low, this can result in
damage to the transmission.
X Make sure that the oil level never exceeds the “HOT-
FULL” or drops below the “HOT-ADD” marking of the
oil dip stick when the oil is at operating temperature.
X Make sure that the operating panel display displays
“oL ok” (oil level is OK) in the oil level mode.
X Use only authorised types of transmission oil.
You can check the oil level with the oil dip stick or read it out on
the display “Oil level mode” in the operating panel.
In order to check the oil level precisely, the following conditions
must be met:
z The MT is parked on level ground.
z The transmission is shifted into neutral N.
z The engine is running at low idle speed.
z The transmission output shaft stands still, i.e. the MT does
not more.
z The oil temperature lies between 60 °C and 93 °C maxi-
mum.
z The transmission oil needs to settle, which means that the
MT has not moved for at least two minutes.
The operational temperature is reached when the
transmission has run under load for at least one hour.
By means of the temperature indicator in the multi-
function display, you can check the temperature for the
transmission oil.
To Next Page
Loading...
