Creating a GOTO Route to a Map Object
This will create a GOTO route to a map object (city, highway, user POI, etc.) that you have
indicated by moving the crosshair cursor on the
Map screen over the map object.
1. While viewing the Map screen, use the Arrow joystick causing the eXplorist to go
into Cursor mode.
2. Continue using the
Arrow joystick to move the crosshair
cursor to the map object that you want to go to.
3. Press
ENTER.
4. Use the Arrow joystick to highlight the map object that you
want to use as the GOTO. (Some areas of the map may have
multiple map objects in the same location.)
5. Press
ENTER.
6. Use the
Arrow joystick to highlight Goto.
7. Press
ENTER.
8. If a GOTO is active, you will be asked to deactivate it and
create a new GOTO route. Highlight
Yes and press ENTER.
After pressing
ENTER, the last viewed navigation screen will be displayed, updated as
needed to provide information about the GOTO route you have created. On the
Map screen, a
line will be drawn representing the GOTO route. The Compass screen will change to display
the name of the POI used as the destination in the screen header bar and an icon
representing the destination outside the compass diameter.
Routes
40
Detail Info
Glendora
34°08.437N
117°51.845W
Glendora
CA
Goto
Save
Sample City Detail screen
with Goto highlighted.
To Next Page
Loading...
Need help?
General