Stopping and Resuming Active Track Logging
This provides the ability to turn off the recording of the active track, and then starting it up
again.
1. Press
MENU.
2. Use the
Arrow joystick to highlight Track Log.
3. Press
ENTER.
4. With Active Track highlighted, press
MENU.
5. Highlight
Stop Logging or Resume Logging.
Note: Stop Logging is displayed only when the active track
is being recorded; Resume Logging appears only when the
active track is not being recorded.
6. Press
ENTER.
Note: The eXplorist will fill in a straight line from the point
that track logging was stopped to the point where it has been
resumed. This is true unless there has been more then four
hours between the stop and the resume logging command.
In that case, the eXplorist will not draw a straight line from
the stop to the resume points of the track.
Track Logs
51
Track Log
Active Track
Apr-24
Apr-28
10.48
Legs Distance
M
I
Track Log List with
information at the bottom
for the number of legs and
the distance of the track
log highlighted.
To Next Page
Loading...
Need help?
General