Magellan eXplorist 510 User Manual

Magellan eXplorist 510 / 610 / 710 User Manual 1
Using the Magellan eXplorist
The Magellan eXplorist GPS receiver is designed to be easy enough for the casual ‘explorer’ as well as having
all of the advance features the ‘enthusiast’ requires. This chapter provides information on the basics of using
the Magellan eXplorist GPS receiver.
Installing the Batteries
The Magellan eXplorist GPS receiver uses two
AA batteries that provides 16 hours of normal use.
(See the section on Power Settings for details as to
how to extend the battery life.) Lithium, alkaline or
rechargeable batteries can be used but both batteries
need to be of the same type and should be dened
in the Tools > Power function in the receiver (see
Setting Battery Type).
Replacing the Batteries
1. Remove the battery door by raising the
arm on the battery door lock and turning it
counter clockwise for one-quarter of a turn.
2. Remove the battery door. The battery
door pivots from the bottom. The
pivot points will release when the top
of the battery door is being raised.
3. Install two AA batteries as shown.
4. Replace the battery door by rst aligning the
pivot tabs at the bottom of the door with the
receiver.
5. Lower the battery door until it seats rmly
against the receiver. (Note: you may need to
turn the battery door lock counter clockwise to
allow the door to seat against the back of the
receiver.)
6. Turn the battery door lock clockwise, locking
the door in place.
Setting the Battery Type
1. With the receiver on and the Map screen
displayed, tap on the map.
2. The Four-Corner Menu screen is
displayed. Tap on the Main Menu
button in the lower left corner.

Magellan eXplorist 510 Specifications

General

Brand	Magellan
Model	eXplorist 510
Category	GPS
Language	English