Magellan MAP 410 User Manual

6 Magellan MAP 410 GPS Receiver
Battery Installation
The MAP 410 uses four AA alkaline batteries that are installed from the
bottom of the receiver. Use the rings to unscrew the water seal battery caps.
Insert the batteries into the battery tubes, with the positive end first, two
batteries in each side, and screw the battery caps until securely closed.
Although it is recommended that four AA batteries be used, in case of an
emergency the receiver will operate with only two batteries if both are
inserted into one of the battery tubes.
If the batteries are left out of the receiver for more than 30 minutes, your
receiver may need to be reinitialized.
+
+
+
+
-
-
-
-
ZOOM
ZOOM
MAP 410

Magellan MAP 410 Specifications

General

Brand	Magellan
Model	MAP 410
Category	GPS
Language	English