Magellan MAP 410 User Manual

46 Magellan MAP 410 GPS Receiver
CUSTOMIZING YOUR MAP 410
Setup
Setup allows you to initialize the receiver and set system
parameters to your preference.
Initialization
By initializing your receiver, you establish the initial
position for the receiver. This will enable the receiver to
search the sky for available satellites. You will need to
reinitialize if you have travelled more than 300 miles while
the receiver is turned off.
Refer to the Getting Started section for more details.
Enabling/Disabling the NAV Screens
You may find that you do not use one, or more, of the nine NAV screens
provided in the receiver. You have the option to disable NAV screens,
except for the SAT STATUS and POSITION screens.
MENU
From
any
screen.
Use UP/DOWN
ARROW KEYS to
highlight SETUP.
ENTER
MARK
MENU
COORD SYS
MAP DATUM
ELEV MODE
PROJECTION
TRIP RESET
WAYPOINTS
ROUTES
SETUP
SUN/MOON
FISH/HUNT
CONTRAST
ALARM/MSG
SETUP
INITIALIZE
NAV SCREENS
COORD SYSTEM
MAP DATUM
ELEV MODE
TIME FORMAT
NAV UNITS
TEMP UNITS
NORTH REF
LIGHT TIMER
BEEPER
PERSONALIZE
CLEAR MEMORY
NMEA
BAUD RATE
SIMULATE
From
any NAV
screen.
MENU
Use UP/DOWN
ARROW KEYS to
highlight INITIALIZE.
Use UP/DOWN
ARROW KEYS to
highlight SETUP.
ENTER
MARK
ENTER
MARK
From
any NAV
screen.
MENU
Use UP/DOWN
ARROW KEYS to
highlight SETUP.
Use UP/DOWN
ARROW KEYS to
highlight NAV SCREENS.
A pop-up
menu will
appear.
You will be
prompted for
each NAV screen.
ENTER
MARK
ENTER
MARK
ENTER
MARK
Use UP/DOWN
ARROW KEYS to
highlight ON or OFF.
WPT NAMES
OFF
ON
WPT NAMES
OFF
ON
WPT NAMES
OFF
ON
NAV 1
OFF
ON

Magellan MAP 410 Specifications

General

Brand	Magellan
Model	MAP 410
Category	GPS
Language	English