English
35
Direct IP
Warning! Using Direct IP requires that you have previously fol-
lowed the entire procedure described in Step-by-Step Proce-
dure for Establishing a GPRS Connection Via Bluetooth on
page 18.
Important Notice! Once you are familiar with the GPRS connec-
tion procedure described on page 18, you don’t need to accu-
rately follow this procedure. Instead, make your Bluetooth and
GPRS connections directly from within the DGPS Configura-
tion utility, using the following buttons located on the Direct
IP Settings window:
- for Bluetooth Manager
- for GPRS
Assuming the GPRS connection is now active, do the follow-
ing to implement the Direct IP DGPS mode:
- Tap on , then Programs>GPS Utilities>DGPS Configuration.
- Tap on the Select Mode button.
- In the Select Differential Mode window, enable the Direct
IP option.
- Tap OK. The Direct IP Settings window opens in which you
can store several Direct IP configurations. [With an already
active GPRS connection, note that the Bluetooth and Dial-
Up fields have been filled in accordingly.].
Each Direct IP configuration holds the key information
allowing MobileMapper CX to connect to a given correc
-
tions provider. Having the capability to save several Direct
IP configurations in MobileMapper CX will therefore allow
you to quickly change the corrections provider without
having to re-enter the relevant connection parameters
each time you do that.
- To enter your first Direct IP configuration, tap
To Next Page
Loading...
