English
37
NTRIP
Warning! Using NTRIP requires that you have previously fol-
lowed the entire procedure described in Step-by-Step Proce-
dure for Establishing a GPRS Connection Via Bluetooth on
page 18.
Important Notice! Once you are familiar with the GPRS connec-
tion procedure described on page 18, you don’t need to accu-
rately follow this procedure. Instead, make your Bluetooth and
GPRS connections directly from within the DGPS Configura-
tion utility, using the following buttons located on the NTRIP
Settings window:
- for Bluetooth Manager
- for GPRS
Assuming the GPRS connection is now active, do the follow-
ing to implement the NTRIP DGPS mode:
- Tap on , then Programs>GPS Utilities>DGPS Configuration.
- Tap on the Select Mode button.
- In the Select Differential Mode window, enable the NTRIP
option.
- Tap OK. The first time you select NTRIP, the message No
NtripCaster specified appears.
- Tap OK to close the message window. This opens the
NTRIP Settings window from which you can store several
NTRIP configurations. [With an already active GPRS con-
nection, note that the Bluetooth and DialUp fields have
been filled in accordingly.]
- Tap . The NtripCaster Connection window opens in
which you can store several NTRIP configurations.
Each NTRIP configuration holds the key information
allowing MobileMapper CX to connect to a given NTRIP
caster. Having the capability to save several NTRIP config
-
urations in MobileMapper CX will therefore allow you to
quickly change the NTRIP caster without having to re-
enter the relevant connection parameters each time you
do that.
To Next Page
Loading...
