.... CHART
PROBLEM CAUSE CORRECTION
Surface burner failsto light, a. powersupplynotconnected, a. connect power, check circuit
breakerorfuse box.
b.cloggedburnerport(s), b. cleanportswithstraightpinorsmall
paperclip.Seepage17forcleaning
instructions.
c. surface control not completely c. turncontroltotheLITEpositionuntil
turnedtotheLITEpositionorturned the burnerignites,thenturncontrol
too quicklyfromthe LITE position, to desiredflame size.
d. powerfailure (pilotlessignition), d. see page 6 to light burner during a
powerfailure.
e. on sealed burner models: Burner e. cleananddryburnerhead.lfbroken
willnotlightiftheignitorisdamaged, or damaged,call a serviceman.
soiled,wet or if the port directly be-
low the ignitor is blocked.
f. burner assemblyincorrectly f. see page 7.
installed.
Burnerflame Is uneven, a. cloggedburnerport(s), a. cleanportswith straightpin.
Surfaceburnerflameliftsoff port a. air/gasmixturenotproper, a. callservicemantoadjustburner.
or is yellowin color, b. no paninplace, b. always place pan on grate before
lightingburner.
NOTE: Liftingof flame is normalfor
sealed burners.Some yellowtipping NOTE: Besureinstallerproperly
withLPgasis normalandacceptable, adjustedrangeattime ofinstallation.
Surfaceburnerignitorproducing a. controlknobis inthe LITEposition, a. be sureALLsurfaceburnercontrol
clicking sound, NOTE:Thelifeoftheignitionsystem knobsareinthe OFFpositionorare
maybeshortenedifthe knobis left adjusted to the desired flame
intheLITE position, setting.
b. surfacecontrolswitchis moistas a b. allowswitchtodrythenrelight
resultofcleaningthe range, burner.
c. malfunctioningswitch, c. callservicemantocheck.
Oven burnerfails to light, a. powersupplynotconnected, a. connectpower,checkcircuit
breakerorfusebox.
b. powerfailure, b. ovenwillnotoperateduringapower
failure.
c. ovenincorrectlyset. c. See page11.
Poppingsound heardwhen Thisisa normalsoundthatoccurswithsometypesofgaswhena hotburneris
burnerextinguishes, turnedoff.The poppingsoundisnota safetyhazardandwillnotdamagethe
appliance.
Clockand/or ovenlight does not a.powersupplynotconnected, a. connectpowersupply,checkcircuit
work. breakerorfusebox.
b. bulbmaybelooseorburnedout. b. tightenorreplacelightbulb.
c. malfunctioningswitch,starteror c. callservicemantocheck.
ballast.
d. malfunctioningclockorloosewiring, d. callservicemantocheck.
(Continuednext page)
To Next Page
Loading...
Need help?
General
