Magicar M100AS - Set-up and Other Functions - Triggers and Code Unlock; Shock Sensor Trigger Sequence; Theft Trigger Sequence; Car Owner Calling Function

S e t - up a nd O t h e r F un c t i o n s
Code Unlock Function
30
Enter the four numbers (1111~9999) as a password, by using a RPS sensor, entering
the correct pass code will unlock the doors, without either remote control or Key.
(“0” should be avoided for a password.)
▶ If you enter the wrong password more than 5 times within 30 min, this
function will not be available for 24 hours.
(The remote will still operate during this 24 hour period.)
▶ If you give up in the middle of entering the password, it will not count
toward the wrong entry count of 5.
No t e
Conditions for Entering the Password the First Time
Key On, but
Engine Off
D o o r s
U n l o c k e d
D o o r
O p e n
Each knock in a set needs to be done within 1.5 sec. of each other. Waiting longer
than 1.5 sec will switch to the next set of knocks.
Green LED should be checked at the first knock.
Conditions for Entering the Password the First Time
Flashes 5 times
Flashes 5 times
Flashes 5 times
29
Shock Sensor Trigger
If the alarm is armed and the shock sensor is triggered by an impact to the vehicle, the
following sequence will occur:
Theft Function (Door, trunk, or hood trigger.)
If the alarm is armed and the door, trunk, or hood is opened, the following sequence
will occur:
Car Owner Calling Function
If the alarm is armed and the RPS function is turned on, when a person knocks on the
RPS sensor, the remote will be paged and will ring like a telephone and vibrate.
S e t - up a nd O t h e r F un c t i o n s
♬ ♪ ~ Beeps for 9 sec
♬♪~ Beeps for 30 sec
♬♪~ Beeps
■CAR : The si r en will activate and the parking
lights will flash for 9 sec.
■Remote control : Vibration/th eft indication
s o u n d .
Remote will beep at 4 second intervals until a
button is pressed.
■CAR : The siren will activate and the parking
lights will flash for 9 sec.
■Remote control : Vibration/the f t indication
s o u n d .
Remote will beep at 4 second intervals until a
button is pressed.
■CAR : The vehicle LED changes f rom red to
g r e e n .
■Remote control : Vibration/telephone r ing.
(4 times)
Remote will beep at 6 second intervals until a button
is pressed.