S
e
t
-
up
a
nd
O
t
h
e
r
F
un
c
t
i
o
n
s
Setting the Shock Sensor Sensitivity
Entering Valet Mode Using a Key
38
Controlling Shock Sensor Sensitivity
To adjust the shock sensor sensitivity, locate the shock
sensor and adjust the dial on the sensor. The higher the
number on the dial, the higher the sensitivity of the
sensor.
※Shock Sensor sensitivity can vary from vehicle to
vehicle for many reasons including where and how it
is mounted, and the size of the vehicle. Some after
install adjustment may be necessary to fine tune the
s e n s o r .
Control of Siren Sound
In order to increase the volume of the siren, locate
the siren, (usually under the hood in the engine bay)
and cut the loop of black wire at the base of the siren.
Be careful not to cut the thicker black ground wire of
the siren.
If the remote has been lost or damaged, you can enter Valet Mode
using the ignition key of the vehicle. The following steps must be
completed within a limited amount of time, so please read
through the instructions before beginning.
1. Turn the key to the “Ignition On”position. When the ignition
is on, the lights in the instrument cluster will turn on. In most
vehicles this position is two “c l i c k s ”forward from the “O f f”
p o s i t i o n .
2. Move the key back one “c l i c k”to the “Accessory On”p o s it i o n .
The lights in the instrument cluster should turn off.
3. Steps 1 and 2 must be repeated for a total of three times within
three seconds. Once this has been done, the alarm will turn off
and valet mode will be active
(Key
B
ox)
<
The higher the numbers,
the more sensitive
>
Valet Mode can only be turned off through the remote
(Press buttons
I
+
I I I
for 0.5 sec. at the same time, the siren will chirp and the
parking lights will flash twice.)
37
Number of Flashes
O n c e
T w i c e
3 times
4 times
5 times
Error Explanation
Engine is already running.
Ignition (Key) is on.
Door open.
Trunk open.
Reservation Mode not set.
(Manual transmission vehicles only.)
If there is a problem remote starting your vehicle, you will hear three chirps from
the remote to indicate that there is a problem. If you go to the vehicle and try again,
an error code will be displayed through the parking lights. The lights will flash
three times, pause, and then flash a number of times equivalent to the error code
number. Example for error code 4, the parking lights will flash three times, pause,
and then flash four times.
Examination of Remote Wakeup Failure
S
e
t
-
up
a
nd
O
t
h
e
r
F
un
c
t
i
o
n
s
Reservation Mode Cancellation in Manual Transmission Vehicles
After Reservation Mode has been set up, it will be cancelled if either the trunk or a
door is opened.
After driving and removing Key, the engine will stay running for 2 minutes. If but
ton I Iis pressed for more than 2 sec. during this time, Reservation Mode will be
cancelled.
If Valet Mode is ON, Reservation Mode will be cancelled.
Remote Wakeup Reservation
●
On the slopes, a car may move. You should not set up
the reservation mode.
Warning!
To Next Page
Loading...
