1. Extension of Remote Start Timer
During the running time, if you press button I for 2 sec. “Start-Again”
will scroll across the screen once and the timer will be reset to the preset time.
2. Remote Start Display
If the remote start confirmation is not received by the remote for different reasons,
pressing any button within range of the vehicle will update the remote and show the
remaining run time.
16
♬♪~Beeps three times after resetting the runtime.
The remaining
runtime will be
reset.
♬♪~Beeps three times after resetting the runtime.
Flashes 5 times
15
B
u
tt
o
n
F
un
c
t
i
o
n
s
Remote Start (ON/OFF)
The vehicle will start and run for a preset time if button II is pressed for 2 sec. If
the vehicle is a diesel, the system will pause for a moment after turning on the igni-
tion to allow time to glow plug warm-up. (If needed.)
●
Vehicle will be armed (if unarmed before start) by getting the signal from remote.
●
If the vehicle fails to start, a second and third attempt will be made.
●
Remote Start will run for the preset time (10, 25, 3, 5min.). If button II is
pressed again for 2 sec. Remote Start will shut off.
●
The remote start running will continue for 20sec after a door opens. The car key
needs to be in On position within the 20 seconds.
●
After the vehicle has been remote started, the remaining run-time will be displayed
on the screen.
●
If the timer goes 1 minute, the remote will warn your with (beep) that the vehicle is
about to shut off.
♬♪~
Beeps three times
The remaining
time is 9min.
and 50 sec.
●
Remote starting should be avoided while people are inside
the vehicle.
●
You will need to turn the key to the ON position in order to
drive the vehicle. Turning the key past the ON position
could cause damage to the vehicle starter.
Caution!
To Next Page
Loading...
