22
21
Option Programming for Six Button(ONE WAY) Remotes
The procedures will be same as the 4 button remotes except
the use of the different buttons.
Programming
Programming Menu 1
Programming Menu 2
Option Selection
Factory Setting
Option Selection
Default Setting Selection
6 Button Remote
(Trunk+Start)-
(Trunk+Stop)-
(Stop)-
Lock
Unlock
(Start)-
4 Button Remote
(I+II)-
(I+IV)-
(IV)
( I )
( II )
( III )
Note :
1-2 Signal Light Flashing :
With this option, the signal will flash if
any door remains open while the vehicle is disarmed.
1-4 Anti-Grinding (Starter-Kill) :
The #1 wire of CN3 can be
programmed to send a signal to a relay to disconnects the starter wire of
the vehicle upon arming and upon remote-start to
prevents you from
recranking the starter on a remote - started vehicle.
Anti-Jacking (Ignition-Kill) :
The #1 wire of CN3 can be programmed
to send a signal to a relay to disconnect the ignition wire of the vehicle
upon anytime the vehicle is armed so that the vehicle cannot start or run
by a remote or a key. And the running of vehicle can be shut off by
remote’s panic command.
Programming Menu #1
Feature
Option
1
4 sec
Starter Delay for Diesel vehicle
Signal-light flash when door
remains open
Duration of Door Lock Output
Application of Pre-wired
Kill Relay
Ignition Unlock
Remote Start Reservation
Cranking Time
N/A
0.8 sec
Anti-Grinding
(Starter-Kill)
Anti-jacking
(Ignition-Kill)
ON
Automatic
Manual
Reservation is
not available
when any door
remains open
For Manual
only
Standard
Standard+ Min
Standard+ Max
OFF
10 sec
Activated
4 sec
(Factory Default)
Button
I
Button
II
Button
III
1-1
1-2
1-3
1-4
1-5
1-6
1-7
Programming Menu #2
Feature
Option
2
Utilization
Turbo
Hour Timer Start
Remote Start Engine
Running Time
AUX 1
AUX 2
Utilization
N/U
N/U
25
Minutes
45
Minutes
5
Minutes
60 sec
Latch
60 sec
Latch
20 sec
0.5 sec
0.5 sec
15
Minutes
20 sec
(Factory Default)
Button
I
Button II
Button III Button IV
2-1
2-2
2-3
2-4
2-5
Note : 2-1, 2-2
If you want to utilize the Turbo mode and 24 Hr mode with your remote
control unit, you need to program the main module at the time of
installation.
To Next Page
Loading...
