4
Installation Tips & Recommendations
3
1-1. Please be careful not to lock yourself out.
Please lower the glass windows before you starting the installation in case the
door locks with the key inside. Also, learn the remote to the brain module after
the installation has been completed.
1-2. Use Digital Multimeter for testing
Use a Digital Multimeter for all testing of wires in the vehicle.
This should be done on all wires even if you feel that you know exactly what they
are and how they should test. Use of lamp tester may damage the electrical
circuit of the vehicle.
1-3. Find Good Ground
One of the most important wire connection is the connection to the ground.
Please find a spot that does not have any resistance to the battery ground.
Improper ground will result in malfunction of the system.
1-4. Make sure your installation does not become a driving hazard
later to the driver.
During installation process, please try to foresee there are any potential
problems to the driver later.
ⓐPotential Driving Hazards
There should be no wiring around the brake.
ⓑConnection problem or Insulation problem
Please make sure all the connections are done by soldering and
properly insulated by the electrical tapes.
ⓒWill any of your installation be affected by the vibration and
engine heat during driving?
Tie securely every components of your installation by use of bolts or
cable tie. Be careful not to damage any wiring inside of the
engine compartment by the engine heat.
ⓓOrganizing wiring after the installation
Improper wiring organization will result in making noisy, connection
problems, safety hazards.
ⓔUser’s familiarity with operating manual
Installer should explain the user thoroughly about the system operation.
1-5. Vehicle check-up prior to and after the installation.
For your protection, check the vehicle inside and out including all of the
vehicle operating conditions and various factory systems to make sure they
work properly after installation in the same manner as prior to the installation.
To Next Page
Loading...
