Pronto 100 ID Card Printer – User Guide
33
Error code 5:8
Reason: While trying to take up the film slack, no tacho pulses were observed within a reasonable amount
of time.
Error code 5:9
Reason: After completing a print job, the printer detected the end-of-film marker.
Error code 5:10
Reason: While trying to move past the transition region between two dye panels, it took too long for the dye
motor to move the required amount.
Error code 5:11
Reason: Just before starting to print a panel, the printer detected the end-of-film marker.
6: FILM INVALID
Error code 6:0
Reason: The fitted dye film had an invalid RFID tag. Either the tag was not programmed correctly or there is
a problem with the RFID tag reader.
Error code 6:1
Reason: A dye film ribbon was detected, but a valid dye film RFID tag could not be found. This printed is not
configured to permit tagless film.
Error code 6:2
Reason: The fitted dye film does not have the right region code for this printer. Try another roll of film.
Error code 6:3
Reason: The fitted dye film does not have the right dealer code for this printer. Try another roll of film.
Error code 6:4
Reason: The fitted dye film does not have the right project code for this printer. Try another roll of film.
Error code 6:5
Reason: The fitted dye film does not have the right grade code for this printer. Try another roll of film.
7: REMOVE FILM
Error code 7:0
Reason: The printer detected film was loaded when trying to calibrate dye LEDs and dye motor.
Error code 7:3
Reason: The printer detected film was loaded when trying to carry out an operation that requires no film to
be present.
8: CAM JAM
Error code 8:0
Reason: While moving the printhead Cam to the closed position, it took too long to detect the trailing edge
of the cam pulley flag.
To Next Page
Loading...
