22
Clock & Alarm
Clock & Alarm
If you subscribe to your network’s Caller Identifi cation
service, the time on your Colombo may be set
automatically each time you receive a call, depending
on your network provider.
You can also set or adjust the time using the Clock &
Alarm menu.
To set date and time
1. Press ‘menu/ok’ and scroll to CLOCK/
ALARM. Press ‘menu/ok’. Display shows DATE
& TIME, then press ‘menu/ok’.
2. Enter the date using the format DD/MM e.g. 04/
08 for 4th August.
3. Press ‘menu/ok’ and enter the time using the
24 hour format HH:MM, e.g. 14:45 for 2.45pm.
4. Press ‘menu/ok’ to confi rm.
5. Press
to return to standby.
NOTE
The date and time is retained during a power failure or when
the batteries are discharged.
To set alarm
1. Press
‘menu/ok’, scroll to CLOCK/ALARM
and press ‘menu/ok’.
2. Scroll
to SET ALARM and press ‘menu/ok’.
3. Scroll or to OFF, ON ONCE or ON DAILY
and press ‘menu/ok’.
4. If you select ON ONCE or ON DAILY, enter the
time using the 24 hour format HH - MM e.g
14:45 for 2:45pm and press ‘menu/ok’.
5. Press
to return to standby. When the
alarm goes off, press any key to stop the ring.
NOTE
Once the alarm is set to on, the icon is displayed. The
alarm will ring at the medium level and ALARM ON will fl ash
on the display.
To set alarm melody
There are three alarm ringtones.
1. Press ‘menu/ok’ and scroll
to CLOCK/
ALARM. Press ‘menu/ok’.
2. Scroll to ALARM TONE and press ‘menu/
ok’. Melodies are played.
3. Scroll or and press ‘menu/ok’.
Colombo UG.indd Sec6:22Colombo UG.indd Sec6:22 24/7/08 17:27:3024/7/08 17:27:30
To Next Page
Loading...