36
Help
Help
The handset is not charging when the
handset is placed on the base
• The handset has been placed the wrong way
around, make sure that the charging contacts on
the handset line up with the charging contacts
on the base. The LED will be RED (or ORANGE if
the answering machine is switched on) when the
handset is charging.
- Poor charging contact, move the handset
slightly, until you hear a beep
• Dirty contacts - Unplug from the mains power
and clean the charging contacts with a cloth
(Do not get wet, do not immerse in water)
No dialling tone
• No power - check the connections. Reset the
phone: unplug and plug back in the mains
• Batteries are empty - charge the batteries for
at least 24 hours. Replace the rechargeable
batteries.
• You are too far from the base - move closer to
the base
• Wrong line cord - only use the telephone line
cord provided
• Micro fi lter (when required) is not connected to the
line cord - connect the micro fi lter to the line cord
Poor audio quality
• The base is too close to electrical appliances,
reinforced concrete walls or metal door frames
- move the base at least one metre away from
any electrical appliances
The signal icon is blinking
• Handset is not registered to the base - register
the handset to the base
• You are too far from the base - move closer to
the base
No ring tone
• The ring tone is deactivated.
• Increase the volume.
Caller Line Identifi cation (CLI) service
does not work
Check your subscription with your network operator
A phonebook entry cannot be stored
• The phonebook is full. Delete unused entries.
No display
• Try recharging or replacing the batteries.
• Try disconnecting and connecting the base
power supply.
Colombo UG.indd Sec20:36Colombo UG.indd Sec20:36 24/7/08 17:27:4524/7/08 17:27:45
To Next Page
Loading...