34
The Answering machine
Remote access
Remote access allows you to operate your answering
machine and listen to your messages by calling your
Colombo from another phone.
The default setting is on.
1. Call your Colombo. When you hear your
outgoing message, press #.
2. Enter your 4 digit PIN. The default code is 0000.
You hear a confi rmation beep.
NOTE
You should change this code for additional security, see
‘PIN’ .
3. After entering your PIN as stated above, use
the keypad to operate your Colombo answering
machine:
1 Play previous message
2 Play messages
3 Play next message
6 Delete message playing
7 Switch answer machine on
8 Stop playback
9 Switch answer machine off
Note
When the answer machine is switched off it will still answer
after 20 rings.
To turn Remote Access on/off
1. Press ‘menu/ok’
,
scroll to ANSW MACHINE
and press ‘menu/ok’.
2. Scroll to ANSW SETTINGS and press
‘menu/ok’.
3. Scroll
to REMOTE ACC and press ‘menu/ok’
4. Scroll
or to select ACTIVATED or
DEACTIVATED.
5. Press ‘menu/ok’ to confi rm.
Call screening
Use your handset or base speaker to hear a caller
leaving a message. You can then choose to ignore the
caller or pick up the call.
The default settings are:
• Handset call screening: On
To interrupt at the handset:
1. If you want to interrupt and take the call press
or
.
Switch handset call screening on/off
1. Press ‘menu/ok’
,
scroll or to ANSW
MACHINE and press ‘menu/ok’.
2. Scroll to ANSW SETTINGS and press
‘menu/ok’.
3. Scroll to HS SCREENING and press ‘menu/ok’.
4. Scroll
or to select ON or OFF.
5. Press ‘menu/ok’ to confi rm.
Colombo UG.indd Sec21:34Colombo UG.indd Sec21:34 24/7/08 17:27:4324/7/08 17:27:43
To Next Page
Loading...