1. Make sure that the motor body is unplugged from power source before inserting
or removing the blade assembly and before cleaning.
2. DO NOT immerse the motor body and adapters into liquids. Clean the device
with a damp sponge or cloth.
3. The housing base may be wiped clean with a soapy, nonabrasive material. Be sure
to dry it thoroughly.
4. Remove the adapters and attachments by twisting them.
5. Hand Washing: Wash the food processor bowl, chopper blade in warm soapy
water. When washing the chopper blade, use a dish-washing utensil with a
handle to avoid contacting with sharp edges. Rinse and air dry thoroughly.
6. DO NOT use any chemical reagents to wash or clean the application.
7. All parts except the housing base are dishwasher safe, and we recommend
washing them in the dishwasher on the top rack only.
8. Due to intense water heat, washing the food processor bowl, cover and
accessories on the bottom rack may cause damage over time. Insert the cover
with the feed tube facing up to ensure proper cleaning. Insert the food processor
bowl and pusher upside down. Remember to unload the dishwasher carefully
wherever you have placed sharp blades.
9. To simplify cleaning, rinse the food processor bowl, cover, pushers and blades or
discs immediately after use so food won’t dry on them. Be sure to position the
pushers upside down for drainage. If food lodges in the pusher, remove it by
running water through it or any smaller cleaning brush.
10. If you wash the blades, discs by hand, please be carefully. When handling, use the
plastic hubs. Avoid leaving them in soapy water where they may disappear from
sight. To clean the blades, hold the blade by its plastic parts or blunt part.
11. If the feet leave spots on the counter, spray them with a spot remover and wipe
To Next Page
Loading...
