Mahindra e Max 25 HSTs - DRIVING THE TRACTOR

► ADJUSTMENT OF THE YOKE ROD ON THE LOWER LINK
For different applications change the position of the
Yoke rod on the lower link holes as shown and insert
the pin in the direction of the arrow.
Only use drawbar to tow and keep the 3 point linkage in the raised position when
towing with the drawbar
Lift Rod
towing
with
the
drawbar
.
Position can create unbalance causing the tractor to roll-over & result in the death
or serious injury.
Danger
► MOUNTING IMPLEMENT
If the PTO is used, remove the safety cover from the PTO shaft.
Adjust the yoke rod on the lower links to suit the implement
Adjust
the
yoke
rod
on
the
lower
links
to
suit
the
implement
in use.
Attach the left lower link, then attach the right lower
link using the adjusting handle on the leveling box if required.
Attach the top link.
Attach the PTO shaft to the tractor if used,
making sure that it is locked in place
Do not attach a PTO shaft with the engine running and ensure all safety shields are
in place.
making
sure
that
it
is
locked
in
place
.
Adjust the check chains to suit the implement and tighten the
locknuts. To remove an implement reverse the procedure.
Caution
Caution
42