Mahindra Maxximo Mini Van Vx 2012 - Page 220

Diagnostic Manual MAN-00183
MAXXIMO MINIVAN VX June 2012/Rev 1
The reproduction, translation, transmission, in part of or whole of the present document are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any
person other than the trained personnel, at the Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution. © 2012 Mahindra &
Mahindra Ltd.
220
 Connect the smart tester
 Turn the ignition ON
 Initialise the diagnostic tool
 Record the error codes and clear
 Turn ignition OFF
 Turn ignition ON
 Verify if P1648 is present?
Is voltage 3.0 to
3.5V for C04
and 4.75 to
5.25V for C55?
N
O
Does continuity
exist?
YES
Go to Step 4
Go to Step 3
 Ignition OFF
 Accelerator pedal sensor
connector DISCONNECTED
 ECU connector CONNECTED
 Check the continuity between
pin D and pin E of the
accelerator pedal sensor
connector
Step 2
N
O
 Ignition OFF
 Check for any loose
or intermittent
connection of
accelerator pedal
 Clear the error codes
and verify
YE
S
 Turn ignition OFF
 Accelerator pedal sensor
connector
DISCONNECTED
 Turn ignition ON
 Measure the voltage
between pin D of the
accelerator pedal connector
and battery negative
Ste
p
1
 Clear the error codes and
verify
Is P1648 is present?
YES
N
O