Mahindra USA, Inc. All Rights Reserved.
23-5
A hot engine cooling system is dangerous. Never add coolant to a
hot engine coolant system, always wait for the engine to cool down
first. You and others could be badly burned by steam or boiling
coolant. Contact your authorized ROXOR dealer for service if your
vehicle overheats.
Do not replace the OEM radiator pressure cap with a non-
standard pressure cap. These will not allow the recovery system to
function properly, causing the engine to overheat and a limited
warranty claim to be denied. Your ROXOR authorized dealer can
provide the correct replacement part.
23.7 Check Engine Oil Level and Leak Check
The oil dipstick is located on the passenger side of the engine.
Engine oil should be checked on a level surface, with engine cold,
or allow time for the oil to drain back into the oil pan before
checking level to prevent overfilling.
1. Position the ROXOR on a flat level surface.
2. Stop the engine and allow time to cool.
3. Unlatch and lift the hood, then place prop rod.
4. Remove the dipstick. Wipe it dry with a clean cloth.
5. Reinstall the dipstick, then remove it and check the oil level.
6. Maintain the oil level in the safe range, between the two
notches. (Refer to the below image) Do not overfill.
Maintenance Procedures
To Next Page
Loading...
Need help?
General
