To Next Page

To Previous Page

6-17

positive location with the added benefit of easier and quicker

installation.

• When using the “ISOFIX” lower latch system (rod), all unused

vehicle rear seat belt metal latch plates or tabs must be

latched securely in their seat belt buckles and the seat belt

webbing must be retracted behind the child restraint to

prevent the child from reaching and taking hold of un-

retracted seat belts. Unlatched metal latch plates or tabs

may allow the child to reach the un-retracted seat belts

which may result in strangulation and a serious injury or

death to the child in the child restraint.

• Child restraint anchorages are designed to withstand only

those loads imposed by correctly-fitted child restraints.

Under no circumstances are they to be used for adult seat

belts, harnesses or for attaching other items or equipment

to the vehicle

HHooww ttoo uussee tthhee TToopp TTeetthheerr//RReeaarr AAnncchhoorr

There are two top tether rods/rear anchors on the seat base back

side of the rear row front facing seats.

1. Remove the headrest from the rear row seat

2. Place the child restraint on the rear row seat

3. Connect the tether connector in child restraint to the top

tether rod/ rear anchor. Securely tighten the child restraint

by adjusting the webbing of the child restraint system (CRS)

tether connector. Follow the clear instructions provide in the

CRS manual

• The top-tether/ rear anchor is the supplemental device to

secure the child restraint system after engaging it by the

SSEEAATTSS AANNDD SSEEAATT BBEELLTTSS

Mahindra THAR User Manual

Questions and Answers: