9-16
© Copyright Mahindra and Mahindra Ltd. 112020
99..1122..33 FFlliicckk--WWiippee ((MMiisstt))
Push the wipe control stalk to position A for a flick-wipe, hold to
operate the wipe continuously (simultaneously lift the wiper stalk
towards the steering wheel to operate the wash). The stalk
automatically comes back to position B when released.
99..1122..44 IInntteerrmmiitttteenntt ((IINNTT)) MMooddee
Intermittent (INT) wiping is selected when the wipe control stalk is
pushed down to position C. In the INT mode, the wiper operates on
preset intervals.
The delay between each wipe can be programmed from 1 to 60
sec according to the rain by the user.
Programming of the INT delay time is as follows;
• Turn the wiper stalk to position C, wiper will start wiping
• Turn the wiper stalk to OFF position, before wiper starts second
wipe
• Turn the wiper stalk to position C again after the required delay
and the same delay will be programmed
• On keeping wiper ON position C, the wiper will wipe again with the
programmed delay
99..1122..55 LLooww SSppeeeedd WWiippiinngg
Push the wipe control stalk up to the position D to operate the
wiper at a fixed low speed.
99..1122..66 HHiigghh SSppeeeedd WWiippiinngg
Push the wiper control stalk up to position E to operate the wiper at
a fixed high speed.
99..1122..77 WWiippee//WWaasshh
Pull/Lift the wiper control stalk towards the steering wheel from
any position to activate the front wipe/wash function. Washer fluid
is sprayed on the front windshield and the wipers wipe the
windshield 3 times after the washer spray is stopped and wipe once
FFEEAATTUURREESS AANNDD CCOONNTTRROOLL
To Next Page
Loading...
