17-16
© Copyright Mahindra and Mahindra Ltd. 112020
The fluid level in the reservoir should be checked on a level
surface with the engine OFF to prevent injury from moving parts
and to ensure accurate fluid level reading.
Follow the below steps for checking and topping up the power
steering fluid;
1. Start the engine and let it run until it reaches normal operating
temperature
2. While the engine idles, turn the steering wheel left and right a
couple of times
3. Turn the engine OFF
4. Check the power steering fluid level in the reservoir
5. The fluid level should be maintained between the ‘‘MMIINN’’ and
‘‘MMAAXX’’ marks on the dipstick, integrated with the cap
6. If the fluid is low, add fluid in small amounts, continuously
checking the level until it reaches the correct operating range.
Be sure to put the cap back on the reservoir
7. With a clean cloth, wipe any spilled fluid from all surfaces
Changing of power steering fluid should always be done by an
Authorized Mahindra Dealer.
1177..55..99 WWiinnddsshhiieelldd WWaasshheerr FFlluuiidd TToopp--uupp
Top up the windshield washer reservoir as and when required. The
fluid reservoir is located on the RHS of the engine bay behind the
head lamp. The reservoir supplies washer fluid to both front and
rear (if equipped).
In very cold weather conditions, fill the reservoir with washer fluid
premixed with anti-freeze.
If you operate your vehicle in temperatures below 4.5ºC, use
washer fluid with anti-freeze protection. Failure to use washer
fluid with anti-freeze protection in cold weather could result in
impaired windshield vision and increase the risk of injury or
accident.
MMAAIINNTTEENNAANNCCEE
To Next Page
Loading...
