© Copyright Mahindra and Mahindra Ltd. 112020
2-15
The tool kit consists of,
• Screw Driver
• Wheel Spanner
• Jack Operating Lever
• DEO Spanner 10mm x 12mm
• Wrench tool for Water drain in fuel
22..55..22 SSppaarree WWhheeeell RReemmoovvaall
The spare wheel is mounted on the rear end of the vehicle. It is held
in place by a securing nuts.
• Loosen and remove the securing nut counter clockwise with a
wheel spanner
• Slowly support and lower the spare wheel
22..55..33 WWhheeeell NNuutt LLoooosseenniinngg
Always loosen the wheel nut before raising the vehicle. Turn the
wheel nut counter clockwise to loosen as per the crisscross
sequence shown. To get maximum leverage, fit the spanner to the
nut so that the handle is on the left side. Grab the spanner near the
end of the handle and push down on the handle. Be careful that the
spanner does not slip off the nut. Do not remove the nut, but loosen
them by one or two turns.
Do not apply force with your legs (or stand) on the wheel
spanner while loosening/tightening the wheel nuts.
GGEENNEERRAALL
To Next Page
Loading...
