5-6
© Copyright Mahindra and Mahindra Ltd. 112020
• REGEN screen will go OFF if REGEN telltale turns OFF.
• When in the REGEN screen of the drive info menu, long Press
OK button to start park regeneration.
• Once regeneration starts, “In Progress” text will appear below
REGEN. The engine idle speed will increase indicating
regeneration has started..
• Park Regeneration can take up to 30 minutes to complete. Once
completed the REGEN warning lamp in the instrument cluster
will turn OFF. The engine’s idling speed also returns to normal
Park Regeneration process may not start if CHECK ENGINE
LAMP or OBD are ON in the cluster. Take vehicle to Mahindra
authorised dealer for assistance.
When Park regeneration is happening do not press the
Accelerator, Brake or Clutch pedals as this will cancel the
regeneration process.
When Park regeneration is happening, switching off the ignition
will cancel the regeneration process. The park regeneration
process may not start if requested when the engine is switched
ON again. Take the vehicle to highway and drive for 20– 30
minutes @ speeds above 60kms/hr until DPF warning lamp
turns OFF
((oorr))
TTaakkee vveehhiiccllee ttoo MMaahhiinnddrraa aauutthhoorriisseedd ddeeaalleerr ffoorr aassssiissttaannccee
DDiieesseell FFuueell
It is recommended to use the regulated automotive diesel fuel
confirming to IS 1460: 2017 spec only.
If the diesel fuel with high sulfur content (more than 10 PPM)
and unspecified additives are used, it can cause the DPF
system damage and emission warranty issues.
• During the regeneration process, take care the vehicle is not
near any flammable materials as you may observe hot
emission gases from exhaust pipe.
• In order to avoid burns & personal injury, stay yourself away
from exhaust system.
• Follow speed limits & traffic regulations as defined by local
jurisdiction while doing forced regeneration.
EEMMIISSSSIIOONN CCOONNTTRROOLL SSYYSSTTEEMM -- AApppplliiccaabbllee ffoorr DDiieesseell
To Next Page
Loading...
