Operation Manual easyTymp
Before starting a measurement make sure, that the device
works properly.
Use and store the device indoors only. For operation,
storage and transport conditions see table in section 6.
For operation in certain places, a recalibration may be
necessary.
No modification of this equipment is allowed.
Equipment is not user repairable. Repairs must be
performed by a qualified service representative only. No
modifications of the equipment are allowed by anyone other
than a qualified MAICO representative. Modification of the
equipment could be hazardous. No part of the equipment
can be serviced or maintained while in use with the patient.
Do not drop or otherwise cause undue impact to this device.
If the device is dropped or otherwise damaged, return it to
the manufacturer for repair and/or calibration. Do not use the
device if any damage is suspected.
Calibration of the device: The device and the transducers
complement each other and share the same serial number
(i.e. MA7663252). Therefore, the device shall not be used
with any other transducer prior to recalibration. Recalibration
also needs to be conducted, when a defected headphone is
replaced.
Uncalibrated devices may lead to faulty measurement results
and could even damage the hearing of the examinee.
2.6 Electrical Safety and Measuring Security
This icon indicates that patient applied parts of the device
conform to IEC 60601-1 Type B requirements.
The protection class of the system depends on the used
power supply.
In case of emergency, disconnect the device from the
computer.
In case of emergency, disconnect the device from the power
supply.
To Next Page
Loading...
Need help?
General
