This section provides information on:
unpacking the system
becoming familiar with the hardware inclusive connections
how to store the device
becoming familiar with the Probe and the External Probe
using the MPT-II thermal printer
4.1 Unpacking the system
Check Box and Contents for Damage
It is recommended that you unpack your easyTymp carefully making sure that all
components are removed from the packing materials.
Verify that all components are included as shown on the packing slip included with
your shipment.
If any component is missing, contact your distributor immediately to report the shortage.
If any component appears to be damaged in shipment, contact your distributor
immediately to report it. Do not attempt to use any component or device that
appears to be damaged.
Reporting Imperfections
Notify the carrier immediately if any mechanical damage is noted. This will insure that a
proper claim is made. Save all packaging material so the claim adjuster can inspect it as well.
Report Immediately any Faults
Any missing part or malfunction should be reported immediately to the supplier of the
device together with the invoice, serial number, and a detailed report of the problem.
Keep Packaging for Future Shipment
Save all the original packing material and the shipping container so the device can be
properly packed if it needs to be returned for service or calibration (see section 3.2).
To Next Page
Loading...
Need help?
General
