8
Press the ‘Power/Mode’ button (Ref.) to switch to FM mode.
The rst time you do this, the FM frequency “87.5 MHz” will be
displayed on the screen.
Fully extend the antenna (Ref.).
To scan for available stations with good signal, press the
‘Scan’ button (Ref.). The unit will then start scanning up the
frequency band and play the rst station it nds with a good
signal.
To scan down the frequency band, press and hold the ‘Scan’
button (Ref.) for a few seconds to nd a station with good
signal.
How to tune a specic frequency manually
To listen to a specic frequency, turn the ‘Tune/Snooze/Enter’
dial (Ref.) to move slowly up and down the frequency band
until you are tuned in to the required frequency.
Mono and Stereo
To change between Mono and Stereo, press the ‘Tune/Snooze/
Enter’ dial (Ref.).
Instrucons Guide
FM Radio
To Next Page
Loading...
