5
Ensure that the radio has been charged and view the
battery life on the display when you turn it on. If the
battery icon shows all of the bars illuminated then the
system is fully charged.
To charge the device, use the USB cable provided and plug
it into a computer or a plug (not supplied) that accepts
USB connectors. Plug this into the radio USB charging port
(Ref.)
Also ensure that the earphones are connected (Ref.)
into the top of the system correctly as they are also the
antenna of your radio. Without them, no DAB/FM signal
will be received.
Turn the radio on by pressing the ‘ON/OFF’ button (Ref.)
on the side of the radio. “Welcome to Digital Radio” will
then show on the display.
The radio will then automatically begin scanning for
available DAB stations. The radio will display “Searching...”
and may take a few minutes to scan.
The signal bar will now display on the top right of the
radio screen. If there are no bars, there may be issues with
getting a good connection to stations.
Instrucons Guide
Basic Operation
To Next Page
Loading...
Need help?
General