MAJORITY PARKSIDE GO - DAB;DAB+ Mode

Press the ‘ON/OFF’ button (Ref.). On rst use, DAB radio
will automatically start scanning all stations and save
them.
To auto scan (if the unit has not automatically done so, or
shows no signal), ensure that the radio is in DAB mode by
using the ‘Mode/Key’ button (Ref.). Follow this by holding
the ‘Menu/Info’ button (Ref.) and the screen should then
display “DAB <FULL SCAN>”. Press ‘Select/Preset/Play/
Pause’ (Ref.) to conrm this.
The unit will then start scanning up the frequency band
and store all stations that have a good signal. Please note:
ensure that you are in an area with signal bars displaying.
The radio will automatically save all those stations that
have a strong signal. After searching has nished it will
automatically play the rst station stored.
To listen to any of the stations that have been stored, use
the ‘Next’ and ‘Prev’ buttons (Ref. 3/4) to navigate through
the stations. Press ‘Select/Preset’ to make your station
selection.
When you turn the radio on it will automatically tune to
the same station (DAB, FM or MP3) that was last selected.
6
DAB/DAB+ Mode
Instrucons Guide