MakerBot Replicator 2 - Page 55

55
MAINTENANCE CONTINUED
Updating Your Firmware
Keeping your firmware up to date will ensure that your MakerBot Replicator 2 always
operates at its best. When a new version of your bot’s firmware is available, MakerWare
will display a message letting you know that it’s time to update. To update your firmware,
follow these steps:
1. Locate the USB-A to USB-B cable that came with your MakerBot Replicator 2 and use
it to connect your Replicator 2 to your computer.
2. Choose “Upload Firmware” from the MakerBots menu. MakerWare will walk you through
the rest of the steps necessary to upload new firmware.
TROUBLESHOOTING, DIAGNOSTICS, AND MAINTENANCE
http://www.monomachines.com/
http://www.monomachines.com/