FILAMENT STUCK
Filament can swell inside the extruder and
get stuck. If you cannot unload lament
from one of the extruders, do the following:
1. Go to the LCD panel and select Utilities
> Filament Options > Unload. This option
heats the extruders.
2. Set the extruder arm to the open position.
3. Push about half an inch of lament
through the extruder to clear the blockage.
4. Try pulling the lament out of the
extruder again.
If you are unable to unload filament because
it has broken o inside the extruder, you
might not be able to reach inside the
extruder to clear the blockage. In that case,
see the section Disassembling an Extruder.
PRINTING ISSUES CONTINUED
9TROUBLESHOOTING
To Next Page
Loading...
