MakerBot Replicator - Page 39

the control panel39
3 PRINT COMPLETE
If you are printing a file from Thingiverse, you will be prompted to share a photo. Photos
shared to Thingiverse will appear on the Thing page in the I Made One! section. Sharing a
photo is a nice thing to do – other Thingiverse users will love to see how your prints of their
designs come out.
To share a photo, select Share to Thingiverse. The MakerBot Replicator will take a
photograph of your build area. Push the dial again to post the photo to the Thing page.
If you do not wish to share a photo of your print to Thingiverse, select Back to Menu.
The MakerBot Replicator will send a photograph to the Print History section of your
MakerBot Cloud Library.
PRINT