TroubleshooTing49
CONNECTIVITY PROBLEMS
PROBLEM SOLUTION
The MakerBot Replicator Smart
Extruder is installed, but the
MakerBot Replicator does not
recognize it.
Remove the Smart Extruder and run the extruder
attachment script by going to Utilities > System
Tools > Change Smart Extruder.
Print files don’t appear in USB
storage or internal storage.
Make sure that your print files are in the appropriate
format. Print files for the MakerBot Replicator must
have a .makerbot file extension.
If these solutions don’t solve your issue, or if you are having a problem that doesn’t appear
here, please contact MakerBot Support by emailing support@makerbot.com. See page 56
for more on how to contact MakerBot Support.
To Next Page
Loading...
