RefeRence55
GLOSSARY
SETUP ASSISTANT: The set of tasks
that runs when you turn on the MakerBot
Replicator for the first time. The setup
assistant helps you level the build plate,
load filament and start a test print. You
can access the setup assistant at any time
through the Utilities menu.
SLICING: The process of turning a
3D model into a print file containing
instructions for your MakerBot 3D printer.
The MakerBot Replicator uses print files
with the extension .makerbot.
SMART EXTRUDER: The MakerBot
Replicator Smart Extruder draws the
filament from the spool, melts it, and pushes
it through a nozzle onto the build plate.
.STL: A widely used file format for
3D models.
SUPPORTS: Automatically generated
support structures used to prop up any
sections of a print that will not stand alone.
.THING: A file format used by MakerBot
Desktop that stores additional information
about your 3D model files.
THING: A file or group of files saved to
Thingiverse or to your MakerBot Cloud Library.
THINGIVERSE: MakerBot Thingiverse, an
online community for sharing 3D design files.
USB CABLE: A cable that allows your
computer to communicate with the
MakerBot Replicator.
USB DRIVE: A USB flash drive. You can use
a USB drive to transfer print files to and from
the MakerBot Replicator.
To Next Page
Loading...
