Welcome, let’s get started6
SAFETY AND COMPLIANCE
Safety alert symbols precede each safety message in this manual. These symbols indicate
potential safety hazards that could harm you or others or cause product or property damage.
Warning: The MakerBot Replicator generates high temperatures. Always allow the
MakerBot Replicator to cool down before you reach inside.
Warning: The MakerBot Replicator includes moving parts that can cause injury.
Never reach inside the MakerBot Replicator while it is in operation.
Warning: There is a risk of shock. This product is not user serviceable.
Warning: Do not leave the MakerBot Replicator unattended during operation.
Caution: Do not print using materials that have not been approved by MakerBot for
use with the MakerBot Replicator. Refer to the Specifications section on page 52 for
more information.
Caution: The socket outlet must be located near the equipment and must be
easily accessible.
Caution: In case of emergency disconnect the MakerBot Replicator from the
wall socket.
Caution: The MakerBot Replicator melts plastic during printing. Plastic odors are
emitted during this operation. Make sure to set up the MakerBot Replicator in a well-
ventilated area.
To Next Page
Loading...
