10 ENGLISH
Installing and removing
polishing pad
CAUTION: Only use the hook-and-loop sys-
tem pads for polishing.
CAUTION: Make sure that the polishing pad
and hook-and-loop pad are aligned and securely
attached. Otherwise the polishing pad will cause an
Remove all dirt and foreign matter from the hook-and-
that their centers are aligned.
To remove the polishing pad from the hook-and-loop
Fig.9: 1.2. Hook-and-loop pad
Installing abrasive disc
Optional accessory
CAUTION:
system discs for sanding.
Disc selection
CAUTION: The outside diameter of accessory
must be within the capacity rating of the power
tool.
CAUTION: The rated speed of accessory
must be equal or higher than the maximum speed
marked on the power tool.
Abrasive disc materials
Abrasive materials Basic features Practical
applications
Best for steel,
stainless steel
and metals. Single
material with
Fast sanding
Best for INOX and
sharp and hard
Removing paint
from cars and
Ceramic Best for INOX,
metals and non-fer-
rous materials.
and high resistant
to shock/heat/
wear.
General metal work
Grit size
Grit Practical applications
24/36 (coarse)
60/80 Medium stock removal
Finishing
Installing and removing abrasive disc
CAUTION: Make sure that the twist-on/twist-
Loose attachment will
Remove all dirt and foreign matter from the twist-on/
pad, follow the installation procedure in reverse.
Fig.10: 1.2.
OPERATION
CAUTION: Only use Makita genuine pads for
polishing.
CAUTION: Only use Makita genuine abrasive
disc for sanding (optional accessories).
CAUTION: Make sure the work material is
secured and stable. Falling object may cause
personal injury.
CAUTION:
on the switch handle and the other hand on the
side grip when performing the tool.
CAUTION: Do not run the tool at high load
over an extended time period.
CAUTION: Be careful not to touch the rotating
part.
CAUTION: Before operating the tool, make
sure that the side grip or caps are not loose. If the
NOTICE: Never force the tool.
pad, or shorten tool life.
NOTICE: Continuous operation at high speed
may damage work surface.
To Next Page
Loading...
Need help?
General
