11 ENGLISH
General operation
Fig.11
1. -
2.
handle and the other hand on the side grip.
3. Turn the tool on, letting the wheel reach full speed,
forward over the workpiece surface.
4.
the tool down.
Polishing operation
Fig.12
1. Surface treatment
2.
work surface. Run the tool at low speed to smooth out
wax.
CAUTION: Do not apply excessive wax or
polishing agent.
NOTE: First, perform a test waxing on an inconspic-
uous portion of the work surface. Make sure that the
tool will not scratch the surface or result in uneven
waxing.
3. Removing wax
4.
Sanding operation
CAUTION: Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION: Never run the tool without the
abrasive disc. You may seriously damage the pad.
CAUTION: Always wear safety goggles or a
face shield during operation.
CAUTION: After operation, always switch
complete stop before putting the tool down.
Fig.13
handle and the other on the side handle. Turn the tool
15 degrees to the workpiece surface.
result in poor performance and premature wear to
MAINTENANCE
CAUTION: Always be sure that the tool is
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning dust covers
Fig.14: 1. Dust cover
for smooth air circulation. Remove the dust covers and
clean the mesh.
OPTIONAL
ACCESSORIES
CAUTION: These accessories or attachments
are recommended for use with your Makita tool
accessories or attachments might present a risk of
for its stated purpose.
-
Center.
• Wool pad
• Sponge pad (white)
• Hook-and-loop pad
NOTE:
To Next Page
Loading...
Need help?
General
