15
Sub-fence
This tool is equipped with the sub-fence. It should be posi-
tioned as shown in the figure.
However, when performing left bevel cuts, set it to the left
position as shown in the figure
CAUTION:
• When performing left bevel cuts, flip the fence over to the
left position as shown in the figure. Otherwise, it will
contact the blade or a part of the tool, causing possible
serious injury to the operator.
Sub-fence R
The sub-fence R can be installed on the right side of the
guide fence. Insert the rods of the sub-fence R into the holes
in the guide fence. Tighten the screws which come with the
sub-fence R to secure the sub-fence R.
CAUTION:
• When performing right bevel cuts, never use the sub-
fence R. It will contact the blade or a part of the tool,
causing possible serious injury to the operator.
1. Sub-fence
1
005593
1. Sub-fence
1
005594
1. Sub-fence R
2. Screws
1
22
005595
To Next Page
Loading...
