Makita LS1216 - Section

P 10/ 35
Repair
(5) Remove Ball bearing 608DDW from Helical gear 14 using 1R269.
Remove Retaining ring S-12 from Helical gear 14 using 1R291. If it is difficult to remove the ring in this way,
remove the ring while pushing Retaining ring S-12 with 1R291.
Two Flat washer 12, Rubber washer 12, Spiral bevel gear 32 and Woodruff key 4 can be removed. (Fig. 25)
(6) Separate Grease holder from Gear section by removing two Bind CT4x12 Tapping screws. (Fig. 25)
(7) Hook 1R045 and 1R346 with Bearing box complete, and then push out Helical gear 14 from Bearing box complete by
turning the handle of 1R045. (Fig. 26)
(8) Remove Ball bearing 608DDW from Bearing box complete. (Fig. 26)
(9) Remove Helical gear 27 with Steel ball 4, Gear shaft and Ball bearing 6000ZZ from Bearing box complete. (Fig. 27)
(10) After removing Steel ball 4 and Ball bearing 6000ZZ from Gear shaft, press down Gear shaft using 1R217 and arbor
press. (Fig. 27A)
DISASSEMBLING
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Spiral bevel gear 32, Helical gears 14, Helical gears 27, Helical gears 28 (cont.)
Fig. 27
Fig. 27A
Fig. 25 Fig. 26
1R217
Steel ball 4
Arbor press
Gear shaft
Gear shaft
Helical gear 27
Ball bearing
6000ZZ
Handle of 1R045
1R346
Ball bearing 608DDW
Ball
bearing
608DDW
Retaining ring S-12
Grease holder
Helical gear 14
Flat washer 12
Rubber
washer 12
Spiral bevel
gear 32
Helical gear 14
Bearing box
complete
Woodruff key 4
Bind CT4x12
Tapping screw
(2pcs.)