6
A
I N T R O D U C T I O N
ABBREVIATIONS
F Figure
Cs Tightening torque
P Page
Pr Paragraph
S Section
Sc Diagram
T Table
V Screw
The letter V in the illustrations refers to retaining or adjusting screws.
The number following this letter refers to the number of the same type
of screw in the unit or component described and illustrated. Letters not
followed by a number indicate a single screw. In case of different screws
being referred to in the illustration, the letter V is followed by a number
and a small letter, for instance: (V4a).
Unless otherwise specied, units and components are reassembled by
proceeding in the reverse order of removal.
Before any servicing, make sure that the vehicle is perfectly
stable.
The front wheel should preferably be anchored to the equipment
integral with the lifting board (A).
•
•
•
•
•
•
•
•
To Next Page
Loading...
