2 - 37
DISPLACEMENT TRANSPORT MODE / WORKING MODE
Before moving and using the machine, remove the turret blocking
system 1 (see Fig. A).
The contactor 2 (Fig. B) should be in the position A (transfer of commands on the
desk of the platform).
The access platform has two modes of displacements: the transport mode (Fig.
D) and the working mode (Fig.E) (Direction of advance (Fig. C).
- Transport mode: the access platform arms are in low position. This mode is
used to move at high speed and go beyond the slope of the machine (Fig. D)
(See chapter : CHARACTERISTICS).
- Working mode: One or many arms of the access platform are lifted or the
telescope is gone out. In this mode, the travelling are made with a small speed,
the safeties for the slope and the overload are activated. (Fig. E).
No movement over terrain with a slope greater than the authorised inclination
(see the Chapter: CHARACTERISTICS) or with deformations likely to make the
platform overturn or with the jib higher than horizontal when the machine
is on an unstable surface.
Before driving the platform, ensure that the basket control station is correctly
over the drive wheels; if it is over the steering wheels, the controls will be
reversed compared to the machine’s direction of travel.
USE OF THE PLATFORM
TRANSPORT POSITION
TRANSPORT MODE
REAR
TRAVELLING
FRONT
TRAVELLING
A
2
1
A
B
C
D
WORKING MODE
E
To Next Page
Loading...
