2-25
4 - “MAINTENANCE MACHINE” LAMP
THIS LAMP HAS TWO FUNCTIONS:
1 - This lamp is controlled by a timer, which brings it on every 50 hours worked (Counting
of the number of hours the hydraulic pump has operated).
When the lamp is on (fixed LED), this mean that the machine must be serviced (see
chapter “MAINTENANCE TABLE”).
NB: To deactivate this light, see 7 “Battery charge and timer indicator lights”.
2 - In the event of a fault, the number of flashes indicates the type of fault detected by
the variator:
- 1 flash : Variator parameter defect
- 2 flashes : Command activated before the use
- 3 flashes : Variator in short-circuit
- 4 flashes : Defect contactors of power
- 5 flashes : Sensor synchronisation fault
- 6 flashes : Accelerator, control switch, potentiometer or wire of speed sensor
- 7 flashes : Battery discharged
- 8 flashes : Variator temperature over high
- 9 flashes : Bobbin contactor in short-circuit
-12 flashes : Defect bus connection.
If the LED flashes permanently, stop the access platform.
Consult your dealer
5 - “STATE OF CHARGE OF THE BATTERY” LAMP
The lamp changes of colors according to the state of the battery charge:
The red led:
- The charger is on the initial phase of charge.
The yellow led:
- The battery is charged at 80% of charge.
The green led:
- The battery is charged.
BATTERY AUTONOMY
- The following functions will be switched off when you reach 20% of load, in working
or transport speed position, at the ground backup and maintenance control station or
basket command and control station :
• Raise intermediate arms
• Raise upper arm
• Extend telescope
6 - “DEAD MAN” BUTTON
- As a safety measure, this button must be held down constantly to activate the various
lifting and rotation functions.
4
6
5
647536 (10/04/2017)
150 AETJ C / 170 AETJ L
To Next Page
Loading...
