Manitou 150 AETJ C - Page 93

3-19
C3 - REAR WHEEL REDUCER OIL
EMPTY - REPLACE
- Place the access platform on an horizontal ground in transportation position and the
warm oil of the reducings.
- Raise the back of the platform (using the two sling eyeholes (Fig. C3/1) or any other
means of lifting).
Slide a wooden wedge between the chassis and the ground to ensure
operational safety.
- Remove the rear wheels (Fig. C3/2)
A wheel weighs from 40 Kg to 53 Kg.
- Place the cap of drainage 2 (Fig. C3/3) lower.
-
Place a tray under the cap of drainage and unscrew it.
- Remove the cap 3 (Fig. C3/3) in order to facilitate the drainage.
- Let the oil to drain completely.
Dispose of the waste oil ecologically.
- Put the orifice 2 in the position like in the (Fig. C3/4).
- Fill up with oil (see chapt
er : LUBRICANTS) by the orifice 3 (Fig. C3/4).
- The level is good when the oil reaches the orifice 2 (Fig. C3/4).
- Replace and screw the caps 2 and 3 (Fig. C3/4).
- Remount the wheels (See B2 for the tightening torque).
C3/1
C3/2
C3/3
C3/4
2
3
2
3
1
647536 (10/04/2017) 150 AETJ C / 170 AETJ L