Manitou MC 40 Powershift - Page 70

B6 - MAST GUIDE ROLLERS
GREASE
MC 40/50 POWERSHIFT Série 2
Place the lift truck on level ground with the mast in vertical position and the forks
unused.
Clean and lubricate the following points with grease (See chapter : LUBRICANTS AND
FUEL in paragraph : 3 - MAINTENANCE) and remove the surplus of grease.
1 - Lubricators of upper guide rollers on mast (2 lubricators) (Fig. B6/1).
2 - Lubricators of lower guide rollers on mast (2 lubricators) (Fig. B6/2).
NOTE : With wide tyres OPTION, lift the forks by approximately 2 m so as to grease the
lower guide rollers of the mast through the port 3 (Fig. B6/3).
In case of technical faults, consult
your dealer.
B7 - MAST GUIDE ROLLERS
GREASE
MC 60/70 POWERSHIFT Série 2 + Turbo
Place the lift truck on level ground with the mast in a vertical position and the forks lifted
at approximately 200 mm.
Clean and lubricate the following points with grease (See chapter : LUBRICANTS AND
FUEL in paragraph : 3 - MAINTENANCE) and remove the surplus of grease.
1 - Lubricators of guide rollers on carriage (4 lubricators) (Fig. B7/1).
2 - Lubricators of upper guide rollers on mast (2 lubricators) (Fig. B7/2).
3 - Lubricators of lower guide rollers on mast (2 lubricators) (Fig. B7/3).
In case of technical faults, consult your dealer.
3 - 12
B7/1
B7/3
B6/1
B6/3
1
2
3
B6/2
B7/2
1
1
2
3